Device Binding

wes58

If I have 2 devices. And I bind device #1 with device #2, and bidn device #1 with device #3.
How can I find out what devices is device #1 binded with?
Is it possible to access binding table on device #1?

TL_YB

aps_binding_entry_t g_apsBindingTbl[]

wes58

Ok. Thanks.
I can send the message to bind or unbind the device. And I received status 0 if the binding/unbinding was successful.
But there is no specific message that can be send from the Gateway to the device to request information about what devices are in the binding table?
If there isn't then, I would have to create my own message/cmd type and, then on the device add the code to send response to this message.

By the way,
This entering Captcha is annoying. especially if it doesn't work. How many time can you try.
I tried EcC8, EcG8, Ec68 and nothing works. Why do you have it here?
See attached picture.

TL_YB

You can obtain the binding table of the remote device by sending MGMT_bind_request command from the GW.

/***********************************************************************

 * @brief       Send the command mgmt_bind_req.

 *

 * @param[in]        dstNwkAddr        - destination address of the request

 * @param[in]   pReq        - parameter of mgmt_bind_req

 * param[in]    seqNo                 - the sequence number used by this command

 * @param[in]   indCb                - the indicate callback for mgmt_bind_rsp

 *

 * @return      Status

 *

 ***********************************************************************/

zdo_status_t zb_mgmtBindReq(u16 dstNwkAddr, zdo_mgmt_bind_req_t *pReq, u8 *seqNo, zdo_callback indCb);

Regarding the issue of captcha，i will forward it to the administrator.

I suggest you create a topic in the user feedback section to track this issue.

wes58

TL_YB 发表于 2024-10-17 15:51
You can obtain the binding table of the remote device by sending MGMT_bind_request command from the  ...

Thanks for that. I will try this function.